Napkin Acrylic Nail Art Tutorial Video by Naio Nails


Uploaded by naiouk on 19.02.2012

Transcript:
This next nail that we're going to is an encapsulated napkin design.
you can use any napkins that you can find.
All you have to do is take the extra layers away so that you've just got the design layer left.
Rip a little bit off that you want - don't cut it because you don't want sharp edges
you want nice, rough, ripped edges.
So then that's the piece we're going to use.
This nail's already been tipped and prepped and primed so if you're not sure about that step
then take a look back at those videos now.
We're going to start off by applying a small amount of pink acrylic, quite a wet layer,
to the nail wherever you're going to put the napkin - nice and wet.
Then you can place the napkin on and use your brush to press it down.
Then we're going to use a selection of colours to finish this design off.
So, a little bit like the marbleising technique that we did - place it on nice and wet
it's just a very thin layer of colour.
Just along the edge where you've ripped.
Put a little bit of glitter so you can't see your client's natural nail or any of the tip join.
Then we're going to cap this whole nail now in pink acrylic.
Don't forget to tilt your client's nail down when you're doing your zone three
so that your acrylic doesn't run back into the cuticle
and it's much easier then to get your brush behind it.
With this design it is quite hard to see the edge of the nail so make sure you put an extra little bit
on the edge to make sure you've got enough acrylic on there.
We're going to let that nail set and then we are ready for pinching.
This nail's now ready for pinching.
Place your pinching tool on and leave it there for a few minutes.
Take your pinching tool off now.
This excess tissue, just pull it away and this nail's ready for filing.
The tissue's nice and thin so it will just file off.
We're going to do a little bit of hand-painting on this nail so we need to smooth the surface.
Just use your white block for that.
Get rid of your dust.
So, using a nice fine, detailer brush.
Add a little water to your black paint so that you get more movement out of it,
and find any lines that are already there created by the napkin and highlight them with your black paint.
Then your thicker areas of black you are just going to put some white dots into.
Let that paint dry and then this nail's ready for gel top coat.
Get your client to place the finger into the lamp for two minutes.
That nail is now set and we are going to finish it off with a bit of cuticle oil and massage it in.
That's an encapsulated napkin nail done.